Volkswagen ID.4: Securing a child restraint with a safety belt

If you would like to use a child restraint in your vehicle from the "universal" approval category( u), make sure that it is permitted for the seating position where you would like to use it. You can find the necessary information on the orange ECE approval seal on the child restraint. Refer to the installation options in the following table.

u: universal; x: seat is not suitable for installing a child restraint classified in this group.

Securing a child restraint with a safety belt

1. Pay attention to and follow the information (→ Child restraints).

2. Adjust the height of the safety belt so that the belt webbing runs naturally along the child restraint without any sharp bends in the webbing. For rear-facing child restraints, use the lowest position of the seat belt height adjuster.

3. Route the safety belt according to the instructions provided by the child restraint manufacturer and guide the belt through the child restraint.

4. Make sure the safety belt is not twisted.

5. Insert the buckle tongue into the safety belt buckle belonging to the corresponding seat, until the safety belt buckle latches into place.

Child restraints from the "semi-universal" approval category, where the child restraint is secured by the safety belt and a support foot, must not be secured on the center rear bench seat.

Securing the child restraint with the upper strap (top tether)Securing yourself and the vehicle