Volkswagen ID.4: Seat occupied recognition
Overview of fitting locations - seat occupied recognition
Overview shown for front passenger side as an example
- Seat occupied recognition
control unit - J706-
- ⇒ Rep. gr. 69 ; Removing
and installing
seat occupied recognition
control unit [J706]
- Wiring harness for seat
frame
- Depending on equipment/
version
- ⇒ "3.31 Removing and
installing wiring harness
for seat frame"
- Front right seat heating -
ZX13-
- ⇒ Rep. gr. 74 ; Assembly
overview - seat
heating element
- ⇒ Rep. gr. 74 ; Removing
and installing
seat heating element
[ZX11]/[ZX13]
- Front passenger side seat
position sensor - G554-

Removing and installing seat occupied recognition control unit [J706]
The seat occupied recognition control unit - J706- will henceforth
be referred to as "seat occupied recognition control unit".
Removing
- ⇒ Rep. gr. 72 ; Secure front seat to seat repair stand
- Unclip electrical wire from retainer -3-.
- Disconnect electrical connector -2-.
- Push locking pin completely out of retainer -3-.
- Unclip seat occupied recognition control unit -1- in direction
of -arrow A-.
- Detach seat occupied recognition control unit -1- in direction
of -arrow B-.
![Volkswagen ID.4. Removing and installing seat occupied recognition control unit [J706]](images/manuals/353/volkswagen_id_4_removing_and_installing_seat_occupied_recognition_254.webp)
Installing
Install in reverse order of removal, observing the following:
- Route electrical wire so that original wiring layout is restored.